Pool Safety Fence Dallas TX

Why Estrada

The gate is the part that matters

Pool barrier code is specific, and the gate is where most installs fail inspection. It has to swing away from the pool, close on its own from any position, and latch without help.

We build to the barrier requirements rather than to a look, then confirm the gate on site: released from full open, released from an inch, latched every time. Ornamental iron, aluminium or mesh, depending on whether you want the barrier to disappear or make a statement.

48in minimum barrier height, no external footholds
Self-closing, self-latching gate swinging away from the water
Gaps sized so a 4in sphere will not pass
Ornamental iron, aluminium or removable mesh
Gate function tested and demonstrated before we leave

What we build

Options & configurations

Ornamental Iron

Powder-coated steel or aluminium. Permanent, code-height, and it looks like a fence, not a barrier.

Removable Mesh

Tensioned mesh sections you can take down for entertaining and reinstall in minutes.

Perimeter Barrier

The yard fence itself brought up to barrier spec so the whole lot is the enclosure.

Gate Retrofit

Self-closing hinges and latches fitted to an existing fence that is otherwise compliant.

Owner on every job

In-house crews, no subs

Set deeper than code minimum

Written workmanship warranty

Built for Dallas

Pool Safety Fences for Dallas yards

Pools are everywhere in Dallas County and so are barriers that would not pass a second look: a gate that needs a shove to latch, a 5in gap at a corner post, or a barrier with a horizontal rail on the outside that a child can stand on. We build to the barrier requirements and check the gate the way an inspector would. Where a house sits on the sloped lots around White Rock Lake we measure height on the low side, because that is the side that decides whether the barrier is tall enough.

More fence types

Explore other options

Cedar Privacy Fences

The classic Dallas backyard fence, built so it still looks classic in year eight. Western red…

Ranch Rail Fences

Open, low-maintenance fencing for acreage and frontage. Two, three or four rail in cedar or…

Hog Panel Fencing

Galvanized panel set in a cedar or steel frame. Open enough to keep the view, tight enough to…

HOA Fences

Fences built to your association’s spec, documented for the architectural committee, and…

Common questions

The questions inspectors effectively ask on your behalf.

What makes a pool gate fail inspection?

The latch height, the swing direction, or a closer that does not bring the gate shut from a standing start. A gate has to swing away from the water, close on its own from any position, and latch without anyone touching it. Most failures are one of those three, not the fence.

Does an existing fence count as the pool barrier?

Sometimes, if the height and gaps meet the barrier requirement and every gate into the pool area complies. A perimeter fence built as a privacy fence often does not, particularly at the gates, which is why we inspect what is there before quoting a retrofit.

Is removable mesh enough on its own?

It depends on what it is doing. Mesh is a good inner layer around the water, and in many setups the perimeter fence is still what the code counts. We would rather look at the yard than answer that one in the abstract.

Where inspections are failed

The gate is what fails, nearly every time

Pool barrier requirements exist to stop a small child reaching the water unaccompanied, and the barrier is only as good as its weakest opening. Fences pass inspection routinely. Gates are where the failures are, because a gate has to close and latch itself every single time without anybody thinking about it.

Self closing and self latching, testedThe gate has to swing shut and latch on its own from any position it is left in. We test it that way rather than assuming the hardware does what the box says, and adjust until it does it consistently.
Latch height and reach consideredLatch position is specified so it is not reachable by a small child from either side, including by reaching through or over the barrier. That constrains the design of the gate itself.
No gaps and no climbing aidsSpacing, ground clearance and anything horizontal that works as a foothold all get checked. A compliant fence with a conveniently placed horizontal rail is not doing its job.
Removable mesh versus permanent barrierA removable mesh barrier and a permanent fence solve the same requirement differently. Mesh comes down when children grow up and is less intrusive on a view; a permanent fence is more durable and does more for privacy. Which one suits depends on how long you need it and what the yard has to look like meanwhile.

This is the one fence we build where the standard is not a matter of taste. It either performs or it does not, and it has to perform when nobody is watching. Requirements vary between jurisdictions and they do change, so we build to what applies at your address now rather than to what was acceptable when the pool went in. If your existing barrier predates the current rules, an inspection will tell you where it falls short before someone else does.

Pool Safety Fences in Dallas, TX